- Home /
- Prodotti /
- Flight case e borse /
- Flight case, flight bag e rack 19'' /
- Pannelli e adattatori per rack 19'' /
- Cassetti e ripiani per rack 19'' /
- Innox /
- Innox RP SHELF-1 Perforated Inlay
Innox RP SHELF-1 Perforated Inlay
evidenza
Descrizione
Use the highly accommodating Innox RP SHELF-1 comes pre-drilled with various strategically placed screw holes so that separate gear can be neatly mounted onto a 19-inch rack to complete a tight, all-in-one set-up. While a lot of gear will come with rack ears included, some just don't, and this is exactly where the RP SHELF-1 comes in. However, be aware that this inlay will take up a little of the 1U space, so if you're using it to mount a unit that's exactly 1U high, it may be too much, and if you're using an open rack rather than a rack case, then make sure to install this inlay at the top so you don't lose out on any precious rack space.
Specifiche
Caratteristiche
- Unità rack in verticale 1 U
- Sustainable product not specified
- Type of 19-inch accessory inlay
Peso e dimensioni imballaggio incluso
- Peso (imballaggio incluso) 1,3 kg
- Dimensioni (imballaggio incluso) 51,0 x 22,0 x 6,0 cm
Specifiche
- Innox RP SHELF-1
- perforated inlay
- for mounting your own gear
Recensioni
Recensioni da altri paesi
Tradurre tutte le recensioni in Italiano
Le produit mesuse les bonnes dimensions, l emballage est correct, par contre 1 des 3 étagères n'avait pas les trous conformes, rectifié a la perceuse. Sinon RAS vu le prix
Conforme à la description, pas de problème.
Le produit remplie sa fonction correctement !
L'idéal est de bien visé au plateau du rack qui va se positionné dessus, sinon a tendance a courber
Pacchetto convenienza
Innox RP SHELF-1 + Innox RP AC
Innox RP SHELF-1 + Innox IVA 39
Prodotti alternativi di altre marche
Vedi tutti i prodotti nella categoria Cassetti e ripiani per rack 19''
In case this exact info happens to be useful to anyone else, as of writing this, this shelf does not have the proper perforations to match a Roland SC-55mkII front rubber feet screws, that *might* apply to other units around that range as well, but I wouldn't know.
1. The mkII can still be mounted by using the two hind rubber feet screw holes, which line up perfectly with the far end of the shelf and can be used to prevent it from sliding back on or pivoting in the shelf, because
2. The mkII's center case screw does line up with the center perforation slide bar on the shelf and the thread could be used to mount.
However, I had to replace the case screw with a slightly longer screw I had laying around (was M3 threading, I believe), as the mkII's own center screw couldn't reach
Otherwise this rack shelf is solid, well enough finished for the price point and will do it's job for a decent while, I suspect.